Can Present Sensor with Quick Connect electrical 12 bit resolution

12 bit resolution

Seam rotary sensors are not used with Gosling seamers but they ARE used on the fill head raised cylinder on all V2 Gosling units

This M8 3-wire connector cable is used with most Wild Goose Filling systems and has one molded female end and three wires on the other

Corrosion resistance class (CRC): 1 - Low corrosion stress

Can Present Sensor with Quick Connect electrical 12 bit resolutionThe can present sensor is used on all EVO and WG8 10 systems and comes with an assembled 3 wire quick connect Commonly referred to as "First and Last can sensors", this inductive proximity sensor is used to detect the presence of a can at the first fill head and last CO2 purge tube. An additional can present sensor is found near the seamer's entrance. A can must be present at these sensors for the filling seaming cycles to start.